|Posted by JEFFCNC on January 2, 2018 at 6:20 PM|
Smart POST for MasterCAM
JeffCNC customize smart POST for MasterCAM can avoid some mistake.
* Check Compensation.
* Check same tool number.
* Check feed and speed.
* Check rough and finish.
* Check chamfer tool.
* Check clearance.
* Check work offset.
* Check DEFINE TOOL NAME
1, Check Compensation:
Normally we need compensation for finish.
If you use wrong compensation or forget compensation will give alarm:
2, Use MasterCAM programming, is very easy made mistake use same tool number with different diameter or tool type.
If you use same tool number with different diameter or tool type will give
Please see more info
3,JeffCNC customize smart POST for MasterCAM can avoid some mistake.
4,POST can show you if your clearance less than 2.0 inch:
5,POST can show you if you have wrong feed/speed:
6,POST will remind you if you use different WCS:
7,Then you can check and change your clearance:
8,And you can update your feed/speed:
9,You can double check your WCS:
After update and POST again, no any alarm and avoid mistake.
JeffCNC can customize good POST whatever you want, if you want customize new POST, please contact me: [email protected].